Yamaha RX-V1900BL - Manual (Page 87)

83
En
Customizing this unit (MANUAL SETUP)
AD
V
ANCED
OPERA
T
ION
English
3
Select the Bluetooth receiver in the
Bluetooth device list and then enter the pass
key “0000” on the Bluetooth component.
Once this unit completes the pairing successfully,
“Completed” appears.
y
To cancel the pairing, press 9RETURN.
4
Press 9
RETURN to exit from “START
PAIRING”.
• If the connected Bluetooth receiver cannot find any Bluetooth
components, “Not found” appears.
• If a Bluetooth receiver is not connected to this unit, “No
Bluetooth receiver” appears.
Input channels INPUT CH
Use this setting to select the number of channels input
from an external decoder (page 23).
Front left and right channels input jack FRONT
If you set “INPUT CH” to “8CH”, you need to specify the
analog audio jacks at which the front left and right channel
signals output from the connected external decoder are
input.
Choices: CD, TV, MD/CD-R, BD/HD DVD, DVD, CBL/
SAT, DVR, VCR, V-AUX
“FRONT” is available only when “INPUT CH” is set to “8CH”.
Use this menu to adjust the optional system parameters.
■ Display settings
A)DISPLAY SET
You can reset the “OSD SHIFT” and “GRAY BACK” settings
to the initial factory settings by using “VIDEO” of
“INITIALIZE” in “ADVANCED SETUP” (page 103).
Dimmer DIMMER
Use this feature to adjust the brightness of the front panel
display.
Control range: – 4 to 0
Control step: 1
• To make the front panel display dimmer, press 8l.
• To make the front panel display brighter, press 8h.
OSD shift OSD SHIFT
Use this feature to adjust the vertical position of the OSD.
Control range: –5 (downward) to +5 (upward)
Control step: 1
Initial setting: 0
• To lower the position of the OSD, press 8l.
• To raise the position of the OSD, press 8h.
Gray back GRAY BACK
Use this feature to display a gray background in your
video monitor when there is no video signal being input.
Depending on the video signals being input or the system
setting of your video monitor (NTSC or PAL), the OSD may be
displayed abnormally. In such cases, set “GRAY BACK” to
“OFF”.
Notes
Choice Functions
6ch Select this setting if the connected component
outputs discrete 6-channel audio signals.
8ch Select this setting if the connected component
outputs discrete 8-channel audio signals. You
also need to configure the “FRONT” setting
(below).
Note
6 OPTION MENU
Note
Choice Functions
AUTO Displays a gray background on your video
monitor when there is no video signal being
input.
OFF Does not display a gray background on your
video monitor.
Note