Yamaha RX-V3800 - Manual (Page 128)

124
En
Advanced setup
■ Remote control TUNER ID
RC TUNER ID
Use this feature to set the TUNER ID of this unit for
remote control recognition.
Choices: ID1, ID2
• Select “ID1” when the remote control TUNER ID
library code is set to “2602”.
• Select “ID2” when the remote control TUNER ID
library code is set to “2603”.
Setting remote control TUNER ID
1
Set the operation mode selector to D
AMP or
D SOURCE and then press 1TUNER on
the remote control to select the tuner to
change the remote control ID.
2
Press and hold M
LEARN for about 3
seconds using a ballpoint pen or similar
object until “L;TUN” and “TUNER”
alternately appear in the display window (B).
• Be sure to press and hold MLEARN for at least 3
seconds, otherwise the learning process will start.
• If you do not complete each of the following steps within
30 seconds, the setting mode will be automatically
canceled. In this case, start over from step 2.
3
Press 4
ENTER.
The four-digit code set for the selected input area
appears in the display window (B) on the remote
control.
4
Press the numeric buttons (6) to enter the
four-digit remote control code for the input
area you want to use.
*1 The remote control setting.
*2 The setting of this unit.
5
Press 4
ENTER to set the number.
“OK” appears in the display window (B) if the
setting was successful.
“NG” appears in the display window (B) if the
setting was unsuccessful. In this case, start over from
step 2.
6
Press M
LEARN again to exit from the setup
mode.
Notes
LEARN
3 seconds
Remote
control
TUNER ID
code *1
Function
RC TUNER
ID *2
2602
(initial setting)
Operates this unit using the
default code. ID1
(initial setting)
2603
Operates this unit using an
alternative code.
ID2
LEARN