Yamaha RX-V3800 - Manual (Page 45)

PLAYBACK
41
En
BA
S
IC
OPERA
T
ION
English
1
Turn on the video monitor connected to this
unit.
y
• You can control this unit by using the graphical user
interface (GUI) screen. See page 44 for details.
• You can turn on or off the short message displays on the
video monitor. See page 90 for details.
2
Rotate the C
INPUT selector (or set the
operation mode selector to D
AMP and then
press one of the input selector buttons (1))
to select the desired input source.
The name of the currently selected input source
appears in the front panel display and in the short
message display for a few seconds.
3
Start playback on the selected source
component or select a broadcast station.
• Refer to the instruction manuals for the source
component.
• See page 53 for details about FM/AM tuning
instructions.
• See page 56 for details about XM Satellite Radio
tuning instruction.
• See page 62 for details about the iPod operation
with this unit.
• See page 64 for details about playback of Internet
Radio programs and the music contents in the PC
or USB memory devices.
4
Rotate R
VOLUME (or press CVOLUME +/–)
to adjust the volume to the desired output level.
Control range: Mute, –80.0 dB (minimum) to
+16.5 dB (maximum)
y
See page 52 to adjust the level of each speaker.
5
Rotate the O
PROGRAM selector on the
front panel (or press one of the sound field
program selector buttons (O) repeatedly) to
select the desired sound field program.
The name of the selected sound field program appears
in the front panel display and in the short message
display. See page 45 for details about sound field
programs.
Sound field programs cannot be selected when the
component connected to the MULTI CH INPUT jacks is
selected as the input source (see page 42).
y
• Choose a sound field program based on your listening
preference, not merely on the name of the program.
• When you select an input source, this unit automatically
selects the last sound field program used with the
corresponding input source.
Playback
Caution
Extreme caution should be exercised when you play
back CDs encoded in DTS. If you play back a CD
encoded in DTS on a DTS-incompatible CD player,
you will only hear some unwanted noise that may
damage your speakers. Check whether your CD player
supports CDs encoded in DTS. Also, check the sound
output level of your CD player before you play back a
CD encoded in DTS.
y
To play DTS-encoded CDs when using a digital audio
connection, set “Decoder Mode” in “Input Select” to “DTS”
before playback (see page 82).
Before performing the following operations, set the operation
mode selector on the remote control to DAMP.
Basic procedure
CD-R CD PHONO MULTI CH TUNER XM MD/TAPE BD/HD DVD DVD DVR DTV/CBL VCR V-AUX NET/USB
D V D
Currently selected input source
Available input sources
Note
M o v i e
S c i - F i
Currently selected sound field program
Currently selected sound field program category