Yamaha RX-V3800 - Manual (Page 98)

94
En
Graphical user interface (GUI) screen
Unit (Unit)
Selects the unit for displaying the values of “Speaker
Distance” parameter.
Initial setting:Feet (U.S.A. and Canada models)
Meter (Other models)
■ Speaker Level (Speaker level)
Use this feature to manually balance the speaker levels
between the front left or surround left speakers and each
speaker selected in “Speaker Set” (see page 91).
Control range: –10.0 dB to +10.0 dB
Initial setting:
Front L/Front R/Presence L/Presence R/Subwoofer:
0.0 dB
CENTER/Surround L/Surround R/Surround Back L/
Surround Back R: –1.0 dB
Control step: 0.5 dB
y
If your subwoofer can adjust the output volume and the crossover
frequency, set the volume to about half way (or slightly less) and
set the crossover frequency to the maximum.
• The available speaker channels differ depending on the setting
of the speakers.
• If you are only using one surround back speaker, connect it to
the SURROUND BACK SINGLE jack, and adjust the balance
in “Surround Back L”.
Use this menu to adjust the network and USB system
parameters.
■ Network (Network settings)
Use this feature to view the network parameters (IP
address, etc.) or to change them manually.
DHCP (DHCP setting)
Use this feature to select whether this unit can obtain the
network parameters (IP address, subnet mask, default
gateway, primary DNS server and secondary DNS server)
from the DHCP server of the connected network.
IP Address (IP address)
Use this parameter to specify an IP address assigned to
this unit. This value must not duplicate the one used for
other devices in the target network.
Subnet Mask (Subnet mask)
Use this parameter to specify the subnet mask value
assigned to this unit.
y
For most of the cases, the subnet mask value can be set as
“255.255.255.0”.
Default Gateway (Default gateway)
Use this parameter to specify the IP address of the default
gateway.
DNS Server (P) (Primary DNS server)
DNS Server (S) (Secondary DNS server)
Use this parameter to specify the IP address of the primary
and secondary DNS (Domain Name System) servers.
If you have only one DNS address, enter the DNS address in
“DNS Server (P)”. If you have two or more DNS addresses, enter
one of them in “DNS Server (P)” and another in
“DNS Server (S)”.
Setup (Setup)
Select “Setup” to confirm the settings of the “Network”
parameters.
Choice Functions
Meter (m) Adjusts speaker distances in meters.
Feet (ft) Adjusts speaker distances in feet.
Speaker Level Adjusted speaker
Front L Front left speaker
Front R Front right speaker
Center Center speaker
Surround L Surround left speaker
Surround R Surround right speaker
Surround Back L Surround back left speaker
Surround Back R Surround back right speaker
Presence L Presence left speaker
Presence R Presence right speaker
Subwoofer Subwoofer
Notes
Manual Setup (NET/USB)
Choice Descriptions
On Select this setting when this unit can obtain the
network parameters from the DHCP server of
the connected network.
Off Select this setting when you set the network
parameters manually.
Note