Xerox 480cx - Manual (Page 20)

1-8 Getting Started
To connect the WorkCentre 480cx to a computer, follow the
steps below:
CAUTION: Make sure the computer is turned off, and the WorkCentre
480cx is unplugged from the power outlet.
1
Plug the parallel cable into the connector on the back of the
WorkCentre 480cx. Swing the metal clips of the connector inward until
they lock firmly inside the notches on the parallel cable connector.
2
Connect the other end of the cable to the parallel port on your computer.
Refer to your computer documentation for assistance with this
procedure.
!
Print the 480cx User Guide