Smart Technologies FSSBID 100 - Manual (Page 24)

1 4 | A S S E M B L I N G Y O U R S M A R T M O B I L E S T A N D
99-00962-20 REV C0
Adjusting the Shelves
Your SMART Mobile Stand includes two vertically adjustable shelves. The spacing
of these shelves ranges from 2" to 19" (5.1 cm to 48.3 cm). Consider whether you plan
to install a SMART Hub, DVD/Blu-ray player or VCR in your unit when determining
the best height for these shelves. Typically, you will install your DVD/Blu-ray player on
the top shelf, and then install your VCR on the bottom shelf.
TIP
If you ordered model FSSBID 100H, install your SMART Hub SE240
(see page 38) in your SMART Mobile Stand before you install the shelves.
To determine your model of stand, see page 7.
To adjust the shelving in
your SMART Mobile Stand
1. If the shelves are already installed in your SMART Mobile Stand, remove them
from the cabinet, and then remove the eight shelf clips.
NOTE
If you need instructions for removing your rear access panels,
see steps 1 to 3 in Appendix A: Configuring a Rack Mount on page 69
(or the SMART Mobile Stand for Interactive Displays Textless Installation
Instructions ( document 132293 at www.smarttech.com/support ).
2. Install four of the included shelf clips at the desired height for the first shelf.
IMPORTANT
– These clips secure to the cabinet’s left and right front rack rails,
rear support tubing and side wall, as shown in the following illustration.
– Ensure that you leave at least 1" (2.5 cm) of space above equipment
for cooling.