Binatone MRFP-8810 D - Manual (Page 7)

7
ENGLISH
using the “+” and “-” buttons (time can be changed only
when the indication is flashing). Then press the “MENU” but-
ton again to proceed with the setting of minutes, for this pur-
pose also use the “+” and “-” buttons. Confirm the selected
time setting by pressing the “MENU” button.
Set the necessary cooking programme, using the “MENU”
button: set the symbol
on the display (12) opposite the
necessary programme on the control panel (13). Standard
programme running time can be changed using the “+” or “-”
buttons.
The steamer will start operating after you press the “START/
STOP” button.
During the process of cooking a certain amount of water is
evaporated from the water reservoir (6). It is important to
control the water level and this can be done with the help of
the water level indicator (11). In a timely manner refill the
amount of water in the steamer through the opening for water
refill (5).
For an immediate cancellation of the running programme press
the “START/STOP” button and the current time indication
will appear on the display (12). You can resume functioning of
the interrupted programme only by setting it again.
When products in the upper container are cooked, carefully
take it off the steamer and put the cover on the remaining
container(s).
Upon expiration of the time set the steamer will automatically
switch off and in this case you will hear several short beep
tones. The symbol will change for the symbol
, pointing to
and another pointing to .
Do not put away the container for steam condensation (7),
until it gets completely cool.
Be careful when taking hot containers off, because there is a
risk of getting burns. Always use potholders or kitchen gloves
and hold the container only by its handles.
After use unplug the appliance from the power supply.
Delay timer function
By using this function you can choose the starting time of
cooking, for example, to get cooked meals by a certain moment of
time.
Note: when cooking short-life products, it is not
recommended to use the timer function.
Put the necessary ingredients into the steam container (2).
Make sure all parts of the steamer are assembled correctly.
Choose the delay timer function by pressing the “MENU”
button and setting the symbol
opposite the timer indication
on the control panel (13).
Press the “+” and “ ” buttons together and set hours (during
setting time, digits should be flashing). Then press the “MENU”
button again to proceed with the setting of minutes. To change
minutes, use the “+” and “ ” buttons as well.
To confirm, press the “START/STOP” button and the display
(12) will start showing the countdown of time left before start