American Magnetics 03300PS-430-601 High Stability Integrated Power Supply System - Manual (Page 185)

Rev. 5 167
Appendix
Power Supply Details
A.12 Power Supply Details
This section provides the technical details of the individual power supply
component of the AMI Model 03300-430-601 High-Stability Power Supply
System.
Warning
All power supply parameters, both hardware and software, have
been set by AMI, and no field adjustments or reconfiguration of the
power supply should be attempted in the field.
Service must be referred to authorized personnel. Using the power
supply in a manner not specified by AMI may impair the protection
provided by the power supply. Observe all safety precautions noted
throughout this manual.
Note
These individual power supply unit details are provided for
reference only. Some of the basic power supply parameters given in
this section will not apply as configured by the factory in the closed
loop current feedback configuration (incorporating the Model 601
Energy Absorber) under control of the AMI Model 430 Programmer.
Refer to section A.11 on page 165, section A.13 on page 172, and
System Specifications on page 9 for additional specifications
relating to the overall system and individual components.
An AMI Model 430 Power Supply Programmer, two Model 08150PS Power
Supplies, and three Model 601 Energy Absorbers are configured to make
up the 03300PS-430-601 bipolar Power Supply System. Each Model
08150PS operates in this configuration as a +8 volt, +150 ampere,
unipolar, voltage and current stabilized DC supply (introduction of the
Model 601 Energy Absorber reduces the available system voltage to ± 3 Vdc
but provides for bipolar operation). Refer to section A.12.1 for additional
electrical characteristics of the Model 08150PS.
Two Model 08150PS Power Supplies are connected in a parallel
configuration to provide the rated current, the units in parallel operating
under the control of the Model 430 Power Supply Programmer.