A.15.3 procedure, Appendix – American Magnetics 03300PS-430-601 High Stability Integrated Power Supply System User Manual
Page 202
184
Rev. 5
Appendix
Model 430 Firmware Upgrade via FTP
Note
The Addr Assignment (Present) must show “DHCP” as originally set
by AMI.
Note
In the following step, the IP Address is the four part number
separated by periods (.), and will change with each Ethernet
connection.
7.
Use < >/< > to locate IP Address (Present), similar to that
shown in Figure 1.
8.
Make note of the IP Address (Present).
A.15.3
Procedure
Note
The result of each of the following steps is depicted in the figure
appearing above or below the action described. The actual screens
will vary depending on the files and file structure on the users PC or
file server, and whether FileZilla is used as the FTP Client.
1.
Open the FileZilla client application—a screen similar to the
following will appear:
2.
Enter the following information in the applicable fields:
a. Host: the IP Address (Present) as noted previously
+0.00 A — IP Address (Present)
+0.00 Vs
169.254.243.199 (DHCP)