Veris Technologies VIS_NIR Spectrophotometer - Operating Instructions - Manual (Page 34)

Pub# OM17-NIR Shank
3-15
Test/Example Data
In order to gain experience with the software before mapping, test/example datasets are
included with the Veris software. This allows the user to experiment with the system,
without logging data or having GPS signal.
1. Start Operating software ( Start  programs  Veris Spectrophotometer
Software  Veris Data Processing)
2. Select working directory by clicking on folder icon.
Figure 18
3. Set ports (see setting port order)
4. Click on system check (see system check for more information).
- Run through all four external references
- Exit system check
- Start acquisition
5. Close acquisition and exit Veris software.
6. Go to C:\Veris\test data copy all files into the directory that was setup in step 2.
7. Start software again and proceed through the extraction, filter, cluster, sample
(no locations can be stored without GPS), and interpolation. For more information
on each of these steps, see Field Operations.