Veris Technologies VIS_NIR Spectrophotometer - Operating Instructions - Manual (Page 39)

Pub# OM17-NIR Shank
3-20
• Pinch point hazard: to prevent injury, stand clear when raising or lowering any part of
the Veris MSP. Disengage automatic cycling function before working around unit.
• Install all transport locks before transporting or working underneath.
Closing disks: Adjust closing disks as needed to properly close trench and bring residue
over row-cleaned zone. Do not operate these deeper in soil than necessary.
Figure 26 and 27.
Setting toggle trip: In order for shank to trip when encountering an obstacle in the soil,
but not trip excessively, toggle trip pivot must set lower than outboard pivot points.
Adjust top adjustment bolts until pivot bolt is approximately 1/8” lower than outboard
mounting bolts. If shank trips too easily, increase dimension slightly. Caution, setting
this pivot point excessively low may cause shank damage.
Figure 28
Closing Disks
depth adjustment
pin
Closing Disks
angle
adjustments
Toggle trip adjustment bolts:
jam nuts and set bolts
Start with pivot bolt
1/8” lower than
outboard mounting
bolts