Veris Technologies VIS_NIR Spectrophotometer - Operating Instructions - Manual (Page 43)

Pub# OM17-NIR Shank
4-4
Here is a cut away view of the hubcap assembly:
Figure 6
Note: If you are still unable to obtain favorable resistance readings, check for excessive
corrosion at the coulter blade mounting bolts, or the terminal located near the coulter
pivot. It may be necessary to grind the spindle end smooth, if a dimple has developed.
MAINTENANCE: LUBRICATION
• Pinch point hazard: to prevent injury, stand clear when raising or lowering any part of
the Veris MSP. Disengage automatic cycling function before working around unit.
• Install all transport locks before transporting or working underneath.
Rockshaft pivot points
– Each pivot (located at the left and right) contains
an upper and lower grease zerk. Due to the limited motion
of the rockshaft, these should be lubricated on 40-hour
intervals. This may vary based on the number of times the
unit is raised and lowered.
cap
commutator
Setscrew
spindle