VEGA PLICSCOM - Manual (Page 9)

9
3 Product description
PLICSCOM •
36433-EN-130228
5 1 2 +
( ) (-) 6 7 8
4...20mA
1
2
Fig. 5: Interfaces for display and adjustment
1 Spring contacts for display and adjustment module
2 Terminals for the external display and adjustment unit
Connection of more than one display and adjustment module on one
interface or a total of more than two display and adjustment modules,
however, is not supported.
The range of functions of the display and adjustment module is deter-
mined by the sensor and depends on the respective software version
of the sensor.
Power is supplied directly via the respective sensor or the external
display and adjustment unit. An additional connection is not required.
The backlight is also powered by the sensor or via the external
display and adjustment unit. Prerequisite for this is a supply voltage
at a certain level. The exact voltage specifications can be found in the
operating instructions manual of the respective sensor.
The optional heating requires its own power supply. You can find
further details in the supplementary instructions manual "Heating for
display and adjustment module".
3.3 Packaging, transport and storage
Your instrument was protected by packaging during transport. Its
capacity to handle normal loads during transport is assured by a test
according to DIN EN 24180.
The packaging of standard instruments consists of environment-
friendly, recyclable cardboard. For special versions, PE foam or PE
foil is also used. Dispose of the packaging material via specialised
recycling companies.
Transport must be carried out under consideration of the notes on the
transport packaging. Nonobservance of these instructions can cause
damage to the device.
The delivery must be checked for completeness and possible transit
damage immediately at receipt. Ascertained transit damage or con-
cealed defects must be appropriately dealt with.
Range of functions
Voltage supply
Heating
Packaging
Transport
Transport inspection