Printronix P7000 H-Series Cartridge Ribbon Printer - Manual (Page 110)

110
Chapter 4 DIAGNOSTICS
RBN End Action
This menu allows the user to override the normal ribbon low warning and
ribbon out conditions.
• Stop At RBN End (default). When this factory default option is selected
the printer displays a warning message when a ribbon low condition is
reached and display a ribbon out fault when ribbon life reaches 0%.
• Ignore RBN End . When this menu option is selected it overrides the
ribbon low and ribbon out conditions, i.e. no warning or fault messages is
displayed and printing continues even after ribbon life reaches 0%.
However, once the ribbon life reaches an excess wear condition as
indicated by the fault message “420 EXC RBN WEAR / Install New RBN”,
printing will stop and the user must install a new ribbon before printing
can resume.
NOTE: The excess ribbon wear is set below the “Lighter -10” Ribbon End
Point setting.
DIAGNOSTICS
DIAGNOSTICS
(from page 52)
Printer
Tests
Shift Recycle*
All E’s
E’s + TOF
All H’s
All Underlines
All Black
Shuttle Slow
Shuttle Fast
Shuttle Only
Phase Printer
Paperout Adj.
Burnin Test
Print Error Log
Clear Error Log
Adapter Test 1
Ethernet Test 1
Acoustics
Dice 5
Prnt Ribbon Log
Checker
Full Width*
80 col.
76 dots*
(40-112)
32 Megabytes On: 127.7 Hrs.
Print: 8.3 Hrs
Print Strokes:
1370097
Print Lines:
106441
11 inch Pages:
4265
* = Factory Default
1 If installed
2 If a Feature File exists.
Test Width Paper Out
Dots
System
Memory
Print
Statistics
SW P/N + Ver
Software
Build
P/N of File
Feature
File
2
800H
Shuttle
Type