Printronix P7000 H-Series Cartridge Ribbon Printer - Manual (Page 38)

38
Chapter 3 Integrated Print Management System
Changing Ribbon Cartridge
Before changing the ribbon cartridge, determine whether at the end of ribbon
life if you want to make the print lighter (extend the ribbon life) or darker
(shorten the ribbon life). If you want to make the print lighter, go to “Ribbon
End Point” on page 57 and follow the procedures for adjusting the image
density. If you are satisfied with the print darkness, or if you want to increase
the darkness at the end of ribbon life, continue with the following steps.
NOTE: Ribbon cartridge instructions and illustrations shown in the following
section are for the pedestal model. Follow the same procedures for
the cabinet model.
Figure 19. Preparing to Load the Ribbon
1. Open the printer cover.
2. Raise the platen lever as far as it will go.
3. Close the tractor doors.
4. Remove the old ribbon cartridge and discard properly.
TO F
TO F
183816a
Blue Tractor
Door (2)
Platen Lever