Chapter 7 – Printronix P7000 H-Series Cartridge Ribbon Printer User Manual

Page 140

Advertising
background image

140

Chapter

7

Diagnosing Problems

620:POWER VOLT
CHECK*

No

Power Supply Voltage. The
power supply has failed.

Replace power supply board.

622:SHUTTLE
DRIVER CRCUIT*

No

The shuttle driver circuit on
the controller board is
drawing too much current.

Contact your authorized service

representative.

1

623:STACKER FAULT

Yes

Stacker is not functioning
correctly.

Check for obstructions in the
stacker area. If fault persists,
contact your authorized service

representative.

1

624:UPPER DRIVER
SHORT*

No

Upper Driver Short. Hammer
driver circuits on the boards
shorted to ground.

Cycle power to see if the
message clears, if not, contact
your authorized service

representative.

1

625:WRONG E-NET

Remove NIC

Yes

Incompatible network
interface card (NIC) is
installed.

Install a compatible NIC to the
printer then reboot. If this
message still appears, contact
your authorized service

representative.

1

700:A TO D OVERUN*

No

Analog to Digital Overrun.
The analog-to-digital
converter overflowed.

Contact your authorized service

representative.

1

701:ACCESS NULL
POINTER*

No

Access Null Pointer: The
processor tried to access a
pointer that contains nothing
(null).

Contact your authorized service

representative.

1

702:FIRMWARE
ERROR*

No

Application software tried to
perform an illegal printer
function or damaged
memory detected on the
controller board.

Contact your authorized service

representative.

1

703:ILLEGAL
EXTERNAL BUS ACC*

No

Illegal External Bus Access.
Firmware error on the
controller board.

Contact your authorized service

representative.

1

704:ILLEGAL
INSTRUCTION ACC*

No

Illegal Instruction Accessed.
Firmware error on the
controller board.

Contact your authorized service

representative.

1

705:ILLEGAL
OPERAND ACCESS*

No

Illegal Operand Accessed.
Firmware error on controller
board.

Contact your authorized service

representative.

1

706:PAP BAD TABLE*

No

Paper Bad Table. The paper
feed process on the
controller board has a
corrupted table.

Contact your authorized service

representative.

1

Table 10. LCD Message Troubleshooting Table

Displayed Message

Can User

Correct?

Explanation

Solution

Advertising