Printronix P7000 H-Series Cartridge Ribbon Printer User Manual
Page 139
Fault Messages
139
607:CTL VOLT FAIL*
No
Controller Voltage Failure.
15 V failure on the controller
board.
Contact your authorized service
representative.
1
608:DRIVER CIRCUIT
BAD
No
Driver Circuit Bad. The
hammer coil count test
failed.
Contact your authorized service
representative.
1
609:EXHAUST FAN
CHECK
(Cabinet model only)
Yes
Sensors cannot detect
current in fan circuit.
Power off the printer and remove
the paper path (see
Maintenance Manual).
Check
that the fan cable connector is
connected. Check for
obstruction of vents and fan
airway, and remove any
obstructions. Check for items
beneath the printer blocking
cabinet vents. Power back on
the printer. If this message
appears again, contact your
authorized service
representative.
1
613: HAM. COIL BAD
#, #, #, ...etc
No
Hammer coil # failed current
test at power up.
Contact your authorized service
representative.
1
614:HAMMER BANK*
NOT INSTALLED
No
Hammer Bank Not Installed.
Self-test routines do not
detect hammer coils at
printer start-up.
Contact your authorized service
representative.
1
615:HAMMER FAN
CHECK
Yes
Sensors cannot detect
current in fan circuit.
Check that fan cable is
connected. Check for
obstruction of vents and fan
airway; remove any
obstructions. Check for items
beneath the printer blocking
cabinet vents. Power back on
the printer. If this message
recurs, contact your authorized
service representative.
1
617:LOWER DRIVER
SHORT*
No
Lower Driver Short.
Circuit(s) on the hammer
bank or in the hammer bank
power cable shorted to
ground.
Contact your authorized service
representative.
1
619:PAPER FEED
DRIVER CIRCUIT*
See Manual
No
Paper Feed Driver Circuit.
The paper feed driver circuit
on the controller board is
drawing too much current.
Contact your authorized service
representative.
1
Table 10. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation
Solution