Printronix P7000 H-Series Cartridge Ribbon Printer - Manual (Page 22)

22
Chapter 3 The Control Panel
SET TOF
Sets the top-of-form on the printer. This key is active only when the printer is
offline and will not operate if the printer is in a fault condition. The paper
moves down to the print position and aligns to the top-of-form. See the
Quick
Setup Guide for the complete top-of-form setting procedure.
NOTE: If there is any data in the buffer, the paper will move to the last print
position.
PRT CONFIG
In offline mode, PRT CONFIG prints the current printer configuration. This key
requires a confirmation with the ENTER key; pressing any other key will exit
from this function. See “The Configuration Menus” on page 41 for an
explanation of configuration menus.
JOB SELECT/PRINT MODE
In offline mode, this key allows for fast selection of any of the previously
stored configurations or typeface of the printer. Pressing this key causes the
printer to cycle through the following messages: Load Config., Factory Config,
Load Config 1, Load Config 2, Load Config 3,...,Load Config 8.
ENTER
When navigating the configuration menus, ENTER selects the currently
displayed option value as the active value. An asterisk (*) appears next to the
active value on the display. ENTER is also used for starting and stopping
printer tests and generating a configuration printout.
NOTE: The ENTER key must be unlocked in order to function.
See UP + DOWN, below.
The ENTER key lock and unlock function can be configured to be a
key combination other than = + > (see page 108).
UP or DOWN ( = or >
)
Moves up or down between levels in the configuration menus and makes
vertical forms adjustment. After pressing VIEW, press
= or > to adjust the
paper up or down in 1/72 inch increments for fine vertical forms alignment.
When the printer is in offline mode, press
= or > to move through levels in the
configuration menus.