Rainbow Electronics T89C5121 - Manual (Page 29)

29
A/T8xC5121
4164G–SCR–07/06
Smart Card Interface Block (SCIB)
Introduction The SCIB provides all signals to directly interface a smart card. Compliance with the
ISO7816, EMV’2000, GSM and WHQL standards has been certified.
Both synchronous (e.g. memory card) and asynchronous smart cards (e.g. micropro-
cessor card) are supported. The component supplies the different voltages requested by
the smart card. The power-off sequence is directly managed by the SCIB.
The card presence switch of the smart card connector is used to detect card insertion or
card removal. In case of card removal, the SCIB de-activates the smart card using the
de-activation sequence. An interrupt can be generated when a card is inserted or
removed.
Any malfunction is reported to the microcontroller (interrupt + control register).
The different operating modes are configured by internal registers.
Main Features • Support of ISO/IEC7816
• Character mode
• 1 transmit buffer + 1 receive buffer
• 11 bits ETU counter
• 9 bits guard time counter
• 24 bits waiting time counter
• Auto-character repetition on error signal detection in transmit mode
• Auto-error signal generation on parity error detection in receive mode
• Power-on and power-off sequence generation
• Manual mode to directly drive the card I/O