BabyTrend HYBRID 3-IN-1 - Manual (Page 14)

7.0
Toddler Car Seat ( With Built-in
Harness) Installation and Use
25
The belt path routing used to secure this car seat into a
vehicle is dependent on installation WITH or WITHOUT
the Top Tether.
- If the Car Seat is installed WITH the Top Tether, the “FRONT
ENTRY” belt routing MUST be used.
- If the Car Seat is installed WITHOUT the Top Tether, the
“REAR ENTRY” belt routing MUST be used.
Note: Installation with Top Tether is recommended when a vehicle
tether anchor is available.
a. Baby Trend requires using the Top Tether provided with this
Car Seat whenever possible.
b. Installation of a car seat using the Top Tether can make getting
a secure installation easier and can reduce the risk of injury in a
crash. This car seat may be installed without the Top Tether
when a vehicle tether anchor is not available.
See “Belt routing options for installation” section for “FRONT ENTRY”
and “REAR ENTRY” belt routing information.
7.0
Toddler Car Seat ( With Built-in
Harness) Installation and Use
26
7.2
Belt Routing Options for Installation:
Installation WITH Top Tether
“FRONT ENTRY” Belt Routing
The “FRONT ENTRY” belt routing is used to secure the Toddler
Car Seat ( WITH Harness) when installed WITH the Top Tether. The
LATCH lower anchor belt and vehicle seat belts are routed through the
“FRONT ENTRY” belt path in the same way.
“FRONT ENTRY” Belt Routing
• Start by sliding the LATCH belt
or vehicle seat belt under the
Armrest .
• From the front of the car seat,
insert the LATCH connector or
the vehicle seat belt latch plate
into the Belt Path Opening in the
Back Support .
• Pull the LATCH or vehicle seat
belt through Belt Path Opening
and across the back of Back
Support to the Belt Path Opening
on the opposite side .
• From the back of the Back Support, insert the LATCH connector or
the vehicle seat belt latch plate into the Belt Path Opening in the
Back Support .
• Pull the LATCH or vehicle seat belt through and slide the belt under
the Armrest on the opposite side .
1
Armrest
Back
Support
Belt Path
Openings
Top
Tether
5
5
4
4
3
3 2
2
1