BabyTrend HYBRID 3-IN-1 - Manual (Page 46)

89
11.1 Certifications
This Car Seat conforms to all Federal Motor Vehicle Safety
Standards for use in motor vehicles and aircraft. See use modes
below:
TODDLER CAR SEAT Mode ( WITH Harness System):
This restraint IS certified for use in motor vehicles and aircraft.
BOOSTER CAR SEAT Mode ( WITHOUT Harness System):
This restraint is NOT certified for use in aircraft.
11.2 Installation an Use on Aircraft
Only the Toddler Car Seat WITH Harness is approved for use
on aircraft. High-back and Backless Booster Car Seats can’t be
used on aircraft as there are no lap/shoulder belts available to
properly restrain a child.
When using the Toddler Car Seat on an aircraft, follow the
installation steps in “Installation - Lap Belt only WITHOUT Top
Tether” section and secure your child per “Securing Your Child”
section.
11.0
Additional Information
12.0
Cleaning and Maintenance
90
12.0 Cleaning and Maintenance
The hard surfaces of the Car Seat (plastic components and metal
parts) except the Buckle, may be cleaned by wiping
with a solution of water with mild soap. DO NOT use bleach as it
may weaken plastic component. Dry all surfaces with a clean towel.
DO NOT use lubricants of any kind on any of the components of
the Car Seat, including buckle and LATCH system.
To clean the Buckle, rinse or wipe with clean warm
water, no soap. Dry buckle.
Care and Cleaning Harness System Seat,
Back Support and Head Support Pads:
NOTE: Before removing the seat pads, you must first remove
the back support from the Car Seat base. If the
harness is attached to the Car Seat, it is best to loosen
or remove the harness before removing the back
support.
• For care and maintenance, read and follow instructions on
fabric tags.