BabyTrend HYBRID 3-IN-1 - Manual (Page 16)

3. Route the LATCH lower anchor belt using
the “FRONT ENTRY” belt routing as shown
in Section 7.2.
4. Place Top Tether Strap over the top of
the Head Support and rest inside seating
area.
5. Place the Car Seat on the vehicle seat in
a seating location equipped with LATCH
and centered between the LATCH
anchorages (see “Selecting a
Vehicle Seating Location” section).
6. If the vehicle seat back is adjustable, adjust
into the upright position or the position
specified in the vehicle owner’s
manual for use with a car seat.
7. Attach the LATCH connectors on the
Lower Anchor Belt to the vehicle LATCH
anchorages and . Listen for the
“click” when the connectors lock onto
the vehicle anchorage.
8. Pull to check that the connectors
are securely attached .
29
7.0
Toddler Car Seat ( With Built-in
Harness) Installation and Use
7.3.1 Installation - LATCH WITH Top Tether
WARNING!
• Only use the car seat LATCH System in vehicle seating
positions designated by the vehicle manufacturer as LATCH
use position and have anchor spacing of 11 inches (280 mm).
• The car seat must be held tightly by the LATCH System.
• Never attach more than one lower anchor connector or top
tether hook to a vehicle anchorage unless recommended in
the vehicle owner’s manual.
The LATCH attachment system, when used with the Top Tether, may
be used to 50 lbs. (23 kg).
To secure car seat in vehicle:
1. Assemble of the Back Support (see “Assembly and Removal of
Back Support” section).
2. Adjust the harness strap height for your
child – Harness straps MUST be at or
above the child’s shoulders (see
“Changing Harness Strap Height”
section).
30
7.0
Toddler Car Seat ( With Built-in
Harness) Installation and Use
Top
Tether
FRONT
ENTRY
Belt
Routing
1 2
3
1
3 LATCH
Connector
2
Top
Tether