BabyTrend HYBRID 3-IN-1 - Manual (Page 18)

To remove car seat:
1. Loosen Top Tether by pressing the button
on Tether Adjuster and sliding belt through
adjuster .
2. Unhook Top Tether Hook from vehicle tether
anchor. Press up on retainer , unhook
Tether Hook , and remove .
3. Loosen LATCH lower anchor belt by
putting knee in seat and while pressing
down , press the button on LATCH
Adjuster and slide belt through
adjuster .
4. Unhook LATCH lower anchor belt connectors
from vehicle anchors. Press up on retainer ,
unhook Tether Hook , and remove .
NOTE: When removing the LATCH
connector, rotating the connector
90º can asist in removal from
vehicle anchor.
To secure car seat in vehicle:
1. Assemble the Back Support (see “Assembly
and Removal of Back Support” section).
2. Store LATCH Connectors on back
of seat.
3. Adjust the harness strap height for
your child – Harness straps MUST be at or
above the child’s shoulders (see “Changing
Harness Strap Height” section).
4. Place Top Tether over the top of the Head
Support and rest inside seating area.
5. Place the car seat on the vehicle seat in a
seating location equipped with Lap/Shoulder
belt and centered between the Lap/Shoulder
belt anchorages (see “Selecting a Vehicle
Seating Location” section).
33
7.0
Toddler Car Seat ( With Built-in
Harness) Installation and Use
1
1
2 2
3
4
3 4
1
2
1
2
2
3
1
2 3
1
34
7.0
Toddler Car Seat ( With Built-in
Harness) Installation and Use
7.3.2 Installation - Lap/Shoulder Belt WITH Top Tether
WARNING!
• Vehicle seat belt system MUST stay tightly adjusted to car
seat at all times. If vehicle seat belt does not stay tight, read
vehicle owner’s manual and “Vehicle Seat Belts” section in
this manual.
Top
Tether
LATCH Connectors