BabyTrend HYBRID 3-IN-1 - Manual (Page 24)

To secure car seat in vehicle:
1. Assemble the Back Support (see
“Assembly and Removal of Back
Support” section).
2. Store LATCH and Top Tether by
securing LATCH Connectors and
Tether Hook on LATCH/Tether
Storage at bottom of Back
Support as shown.
3. Adjust the harness strap height for your
child – Harness straps MUST be at or
above the child’s shoulders (see
“Changing Harness Strap Height” section).
To remove car seat:
1. Loosen LATCH lower anchor belt by
putting knee in seat and while pressing
down , lift up on LATCH Adjuster and
slide belt through adjuster .
2. Unhook LATCH lower anchor belt connectors
from vehicle anchors. Press up on retainer ,
unhook LATCH Connector , and
remove .
NOTE: When removing the LATCH
connector, rotating the connector
90º can asist in removal from
vehicle anchor.
45
7.0
Toddler Car Seat ( With Built-in
Harness) Installation and Use
1
2
1
2
1
2
3
1
2
3
7.0
Toddler Car Seat ( With Built-in
Harness) Installation and Use
46
7.4.2 Installation - Lap/Shoulder Belt WITHOUT Top Tether
WARNING!
• Vehicle seat belt system MUST stay tightly adjusted to car
seat at all times. If vehicle seat belt does not stay tight, read
vehicle owner’s manual and “Vehicle Seat Belts’ section in
this manual.
1
2
3
LATCH Connectors
Top Tether
Tether/LATCH
Storage