Connecting the hardware – SENA SS800 User Manual
Page 16
Advertising
16
Figure 2-3 The panel layout of the SS400
2.1.4. SS800 Panel Layout
The front panel of the SS800 is nearly identical to the SS400. The SS800 has 8 serial port indicators,
while the SS400 has 4. For further information, refer to the chapter, 2.1.3 SS400 Panel Layout.
2.2. Connecting The Hardware
This section describes how to connect the Super Series to the equipment for initial testing.
- Connect a power source to the Super Series
- Connect the Super Series to an Ethernet hub or switch
- Connect the device
2.2.1. Connecting The Power
Connect the power cable to the Super Series. If the power is properly supplied, the [Power] lamp will
light up green(SS 400/800) or red(SS 100/110).
Figure 2-4 Connecting the power to the SS100/110
Advertising