SENA SS800 - Manual (Page 36)

36
Figure 3-9 NFS server configuration
To store the Super Series log data to the NFS server, the NFS server must be configured as “read and
write allowed”. If there is a firewall between the Super Series and the NFS server, there must be a rule
that allows all outgoing and incoming packets to travel across the firewall.
If the NFS service is enabled and the NFS server configuration is properly set up, the user may
configure the storage location for the system log or port data log of the If there is a firewall between
the Super Series and the SYSLOG server, there must be a rule that allows all outgoing and incoming
UDP packets to travel across the Super Series as the NFS server. For more information about the
configuration of the port/system log storage location, please refer to section, 4.2.11 Port Logging and
6.2 System Logging.
3.8. Ethernet configuration
The Super Series supports several types of Ethernet modes:
- Auto Negotiation
- 100 BaseT Half Duplex
- 100 BaseT Full Duplex
- 10 BaseT Half Duplex
- 10 BaseT Full Duplex
After changing the Ethernet mode, the user must reboot the system. The factory default value of the
Ethernet mode is Auto Negotiation. With most network environments, Auto Negotiation mode works
fine and is recommended. Invalid Ethernet mode configuration may make the Super Series not work in
the network environment.
Figure 3-10 Ethernet mode configuration