Wireless lan card configuration – SENA SS800 User Manual
Page 74
Advertising
74
Figure 5-3 PC LAN card configuration
The user must manually select PC LAN card as the card type and set the primary and secondary DNS
servers when configuring a PC LAN card. All other configuration steps are the same as detailed in
Section 3.1. IP Configuration.
Refer to Appendix 2.PC Card Supported By Super Series to view a list of LAN PC cards supported by
the Super Series.
5.2. Wireless LAN Card Configuration
A wireless LAN card will result in two network interfaces and two IP addresses. The user can assign a
valid IP address to each serial port. The IP address must valid in the Super Series built-in network
interface or in the wireless LAN interface environment.
Advertising