Lan card configuration – SENA SS800 User Manual
Page 73
73
If Super Series fails to discover the PC card, the following error message will be displayed on the
menu screen.
Figure 5-2 Failure to detect error message
Refer to Appendix 2.PC Card Supported By Super Series to view a list of PC cards support by the
Super Series.
To stop or remove the PC card, user must complete the following steps.
Step 1. Select [(Ban- show the actual button) Stop card service].
Step 2. Save the configuration changes by selecting [Save to flash].
Step 3. Apply changes by selecting [Apply changes] from the menu.
Step 4. Remove the PC card from the PC card slot.
Note: Removing the PC card from the slot without following the above instructions may cause a
system malfunction.
5.1. LAN Card Configuration
A LAN card will create two network interfaces and two IP addresses. The users can assign a valid IP
address to each serial port. The IP address must be valid in the Super Series built-in network interface
or the environment of Super Series PC card LAN interface environment.