SENA SS800 - Manual (Page 34)

34
must then enter the IP address and subnet of access. Any user on a remote host must stay in the
specified subnet boundary to have the configuration access.
To allow only a specific host to have configuration access to the Super Series, enter the IP address of
the specific host and just give 255.255.255.255 for the subnet.
To allow any hosts to have access to the Super Series, give 0.0.0.0 for both of the IP address and
subnet. Refer to Table 3-2 for more details. The device’s default settings for remote hosts allowed for
configuration is “Any”.
Figure 3-7 IP filtering Configuration
Table 3-2 Input examples of allowed remote hosts
Input format
Allowable Hosts
Base Host IP address Subnet mask
Any host 0.0.0.0 0.0.0.0
192.168.1.120 192.168.1.120 255.255.255.255
192.168.1.1 ~ 192.168.1.254 192.168.1.0 255.255.255.0
192.168.0.1 ~ 192.168.255.254 192.168.0.0 255.255.0.0
192.168.1.1 ~ 192.168.1.126 192.168.1.0 255.255.255.128
192.168.1.129 ~ 192.168.1.254 192.168.1.128 255.255.255.128
Web access also uses the IP filtering function, which can be enabled or disabled. The factory default
setting is “Enabled”. When enabled, the user can specify a web host or hosts allowed to access the
Super Series for configuration.