SENA SS800 - Manual (Page 86)

86
--->9
Do you want to upgrade firmware? (y/n): y
Transfer firmware by zmodem using your terminal application.
To escape, press Ctrl+X
**B0ff000005b157
**B0ff000005b157
**B0ff000005b157
**B0ff000005b157
Firmware upgrade failed !
Now reboot ...
Figure 6-12 Firmware upgrade failure message
6.10. Security Profile
On Security Profile menu page, user can disable or enable SSHv1 protocol support. And also user can
select the types of HTTPS protocol to be used in the Super Series. Following figure shows the
Security Profile setting web interface.
Figure 6-13 Security Profile
6.11. User File Uploading
User can upload his own file to the Super Series. But file uploading feature is only supported in
console menu. File uploading menu is located under “4. System administration --> 6. User file upload”
of console menu as shown on Figure 6-14.
To upload user file to the Super Series using console menu, user must use a TELNET/SSH or
terminal emulation program which supports Zmodem transfer protocol.
Uploading procedure is similar to firmware upgrade using console menu as follows,
1. Prepare user file to be uploaded.
2. Connect the terminal emulation program using either TELNET/SSH or a serial console port.
(TELNET or SSH is recommended since the process of firmware upgrade by serial console.
Using a serial console port may take a long time.)
3. Select from the user file upload menu as shown Figure 6-14.
4. Follow the online directions and transfer the user file using the Zmodem protocol as shown in
Figure 6-11.
5. Once the upload has been completed, the system will display success messages as shown in
Figure 6-14.