SENA SS800 - Manual (Page 22)

22
users can configure the required parameters guided by online comments. All the parameters are
stored into the non-volatile memory space of the Super Series, and it will not be stored until users
select menu ”5.Save changes”. All the configuration change will be effective after selecting the menu
“7. Exit and apply changes” or “8. Exit and reboot”.
2.2.6. Using Remote Console
The IP address of the Super Series must be known before users can access the Super Series using
the Remote console (see chapter 3. Network Configuration for details). The default IP address of
Super Series is 192.168.161.5.
The Remote console access function can be disabled in the remote host access option (3.5. IP
Filtering for details).
The following instructions will assist in setting up the Remote Console functionality:
1) Run either a Telnet program or a program that supports Telnet functions (i.e. TeraTerm-Pro
or HyperTerminal). The target IP address and the port number must match the Super Series.
If required, specify the port number as 23.
Type the following command in the command line interface of user’s computer.
telnet 192.168.161.5
Or run a Telnet program with the following parameters:
Figure 2-16 Telnet program set up example (TeraTerm Pro)