Elmo Rietschle G-BH1e - Manual (Page 18)

610.44521.40.000 18 / 52 © Gardner Denver Deutschland GmbH
Installation
4.1.3 Mounting
NOTE
Dimensioned drawings with detailed
dimensions, including fastening dimensions,
are provided by the manufacturer.
Horizontal installation
ne2bhxn002d
Fig. 4: Schematic diagram: horizontal installation
Mounting sequence:
1 Select suitable mounting elements.
2 Attach the pump−motor unit to the surface:
– Screw the base of the pump−motor unit to
the surface via the mounting holes.
– When doing so, be sure to provide all
mounting holes with screws!
Vertical installation on the cover of the gas
ring blower (”cover installation”)
NOTE
You need three rubber feet for the "cover
installation" of the pump−motor unit.
The rubber feet are available as accessories.
They come with a stud bolt on one side and a
threaded hole on the other side.
 WARNING
Danger of crushing caused by pump−motor
unit tipping over!
Avoid free−standing installation of the
pump−motor unit!
Always screw the rubber feet to the foundation
or to the installation surface!
Check screw connections regularly for
tightness.
ne2bhxn002c
Fig. 5: Schematic diagram: installation on the cover
of the side channel housing
Mounting sequence:
1 Attach the rubber feet to the pump−motor unit:
– Screw the stud bolts of the rubber feet into
the bore holes in the cover of the gas ring
blower housing.
– Tighten the rubber feet.
2 Mount the pump−motor unit together with the
rubber feet on the installation surface:
– Select suitable mounting elements for the
threaded hole.
– Screw the rubber feet to the installation
surface via the threaded holes.
Vertical mounting on a wall
ne2bhxn002a
ne2bhxn002b
Fig. 6: Schematic diagram: vertical mounting on a
wall