Elmo Rietschle G-BH1e - Manual (Page 28)

610.44521.40.000 28 / 52 © Gardner Denver Deutschland GmbH
Installation
Connection
3/PE AC, 320 V ... 550V, 45 ... 65 Hz
X1 L3 L2 L1 K14 K12 K11
PES
PES
4.3 mm

1.2...1.5 Nm
10.7...13.3 lb-in
6 mm
1.1 Nm
9.7 lb-in
ne2bhxn431
Fig. 14: Connectiing frequency inverter 2FC4302-1NE00 ... 2FC4752-1NE00
1 Connecting the mains cable:
A Pass the mains cable through the cable gland.
B Attach the ring cable lug (Ø 4.3 mm) to the
PE conductor.
C Screw the PE conductor onto the PE stud for
the mains cable:
– observe tightening torque
D Connect cores L1, L2 and L3 to X1 in correct
phase relation:
– observe tightening torque!
2 Wiring the relay output (if necessary):
A Pass the cable through the cable gland.
B Connect the shield of shielded cables
according to EMC requirements (  26).
C Connect cores to terminal X1:
– observe terminal connection diagram and
tightening torque!
3 Connecting the control cable shield:
A Pass the control cable through the cable
gland.
B Connect the shield according to EMC
requirements (  26).
C Control cable connection: ( (  28)
4 Tighten all cable glands.
4.4.5 Wiring of control connections
The control connections are on the control
terminal module 2FX4501−0NE00 which is
included in the scope of supply.
Install the control terminal module in the terminal
box of the frequency inverter before starting to
wire the control connections.
62 7 7 8 9 20 28 E1 E2 E3 E4 39 A1 59
X3
n_e2fx1006
Fig. 15: Control connections 2FX4501-0NE00
Mount control terminal module
CAUTION
If the cap is plugged on the socket
connector when assembling the frequency
inverter, the control terminal module will be
damaged!
 Remove the cap from the socket connector
at the control terminal module.
 Keep the cap.