Removing the valve block from the top-hat rail – Burkert Type 8644 User Manual
Page 13
8644/phoenix - 9
I
NSTALLATION
/ C
OMMISSIONING
Removing the valve block from the top-hat rail
If present, release the adjacent modules /
terminals!
Unlock the Vavle block from the standard rail by
turning the fixing screws anticlockwise as far as
they will go.
Lift the Valve block vertically from the rail.
Disconnect the modules / terminals from the
standard rail following the manufacturer’s
instructions.
The valve block is firmly screwed to a standard rail. Additional electrical modules / terminals can be
mounted on this.
NOTE
The interface of the left-hand connection module contains elements that can be
damaged if force is used.
Never place the valve block on its side, and ensure that you use an approved
installation position!
NOTE
There must be sufficient clearance > 6 mm between Valve block and previous module.