Clear-Com Concert for Newsroom - Manual (Page 21)

21 Administrator Guide
4.4.3 Modifying the details of an Interface Gateway
To modify the details of an Interface Gateway:
1. In Action, click [modify].
2. The Details page for the Interface Gateway is displayed. Make any changes you require.
3. Click Submit.
Tip: You can also modify the details for the Interface Gateway within the Details page for the Interface
Gateway (see below).
Note:
It may take up to 10 seconds for the new Interface Gateway to be created and become configurable. If
you click the Interface Gateway tabs or links too early, an error message will be displayed stating the
Interface Gateway is currently either not reachable or hardware is not present.
The message will be displayed until the Interface Gateway is fully created (a maximum of 10 seconds).
4.4.4 Information pages for the Interface Gateway
The information pages [ ] dedicated to each Interface Gateway are located under the main Interface
Gateway page [ ], and can be accessed directly by clicking either the icon or the name of the
Interface Gateway.
The following pages of information are available for the Interface Gateway:

The Details page (See 4.4.2).

The port - channel configuration page.
Important Note :
The port-channel configuration page (tab) is labeled with the system name of the device(s) to be
controlled, for example, AudioScience ASI56040 (hw: 0,0).
Port - channel configuration
The port-channel configuration page enables you to:

View all available input and output ports on the installed audio device.

Associate server channels to physical ports on the audio device.

Modify or remove those assignments.