Clear-Com Concert for Newsroom - Manual (Page 23)

23 Administrator Guide
4.4.5 Associating a server channel to an unassigned device port
Note :
Ensure that at least one partition exists and that at least one server channel has been created within that
partition. The base Concert installation creates an Intercom partition with four server channels.
To associate a partition’s server channel to an unassigned device port:
1. Choose an input or output port to configure and click [configure] in the Action column
Drop-down menus are displayed in the Partition and Channel columns, and the Action buttons
change to [apply] and [cancel].
2. From the Partition drop-down menu, select the partition from which the server channel will be
chosen (for example, Intercom).
3. From the Channel drop-down menu select the server channel that will be assigned to the
respective port (for example, Partyline1).
4. Click [apply].
Important Note :
Server channels can only be assigned to one input and one output device port on one device.
To connect the configured server channel, click the Disconnected status icon [ ] within the
Click to Modify State column.
Depending on how fast the browser refreshes, a Connecting status icon [ ] may be displayed when
the page refreshes.
Refreshing the page again should result in the Connected status icon [ ] being displayed for the
configuration.
Note:
The connection status does not update automatically. To view the current connection status of the
channel, you must manually refresh the page.
To disconnect the channel, click the Connecting status [ ] or Connected status icon [ ].
When the channel disconnects, the Disconnected status icon [ ] is displayed representing a
Disconnected state of the port
– channel configuration.
To modify/update the channel configuration:
1. Disconnect the channel by clicking the Connecting status [ ] or
Connected status icon [ ].
2. The Action buttons change to [modify] and [remove]. Click [modify].
3. Drop-down menus are displayed in the Partition and Channel columns, and the Action buttons
change to [apply] and [cancel]. Change the partition and/or channel, as required.
4. Click [apply].