A&D Weighing Indicator AD-4405 - Manual (Page 11)

AD-4405 Weighing Indicator Page 9
ZERO key The key to zero the current display.
CLEAR key The key to clear the setting value.
TARE key The key to perform tare.
ESC key
The key to proceed to the next step without changing the
parameter set.
NET/GROSS key The key to select net or gross weight in the display.
+/- key The key to select + or – of a value.
ENTER key Confirms settings and stores the value.
PRINT key The key to print/output data (press and release quickly).
ON/OFF key Turns the indicator on and off (OFF: hold for 3 seconds).
10 Printer cover Printing paper will be stored inside when the printer is installed.
Printer Internal dot matrix printer (optional).
4.1.2. Rear Panel Description
No. Name Description
11 Power cable
Please confirm that the local voltage and receptacle type are
correct for your scale.
12 Grounding terminal Connect to the Earth (M4 size screw).
13 Load cell connector Connect a load cell using the accessory load cell plug.
14 CAL switch cover The CAL switch is located behind the sealing panel [15].
15 Sealing panel For type approval, available with the sealing wire posts.
16 RS-232C connector Exchange this when installing other data output (options).
4.1.3. Other Displays and Symbols
Standby display.
Zero error when turning the display on. If the ESC key is
pressed, the current weighing value may should be displayed.
Over load display. Remove any load from the load cell
immediately. It may cause damage to the load cell.
An example of an error display.
4. Description of Panels and symbols
11
12 13 14
15
16