Electro Cam PS-6144 Series - Manual (Page 39)

3-11 Programming
Group Position Display (Cont’d)
The value selected in this screen determines the appearance of the main screen as
shown below:
Main Screen— • One Output Group, and GRP POS DISP Set to “One” or “Each”
• Multiple Output Groups, and GRP POS DISP set to “One”
PGM: 1 RPM: 1500
MENU< POS: 180 Machine Speed
Machine Position = Shaft Position + Offset
To enter Menu Tree, press SEL when cursor is here
Active Program
Main Screen— • Multiple Output Groups and GRP POS DISP Set to “Each”
PGM: 1 RPM: 1500
MENU< GRP1: 180 Mode 1 or 2: Position = Preset + change since last reset
Mode 0, 3, 4, 5: Position = Shaft Position + Group Offset
Group #: To change, put cursor here and press SEL
To enter Menu Tree, put cursor here and press SEL
Programming Enter the GRP POS DISP function and press SEL to toggle between “ONE” and “EACH.”
• GRP POS DISP must be set to “EACH” to assign different offsets to groups through
OFFSET programming.
• If groups have been assigned different offsets through OFFSET programming, set-
ting GRP POS DISP to “ONE” will immediately change the individual group offsets to
the value of Group 1.
See Also OFFSET
SHAFT POSITION
OUTPUT GROUPS
MAIN SCREEN
Increasing Direction
Menu Path MAIN SCREEN to CONFIG MENU HARDWARE
to INCREASING DIR
Purpose The Increasing Direction screen displays the direction of resolver rotation (CW or CCW
as viewed from the shaft end) that will cause the position display to increase in value.
Screen
This is normally set so the position value increases as the machine turns in its forward
direction.
Changing Direction Press SEL to toggle the value of increasing direction. The new value will begin flashing.
Press the ENT key to confirm your selection.
INCREASING
DIR: CCW<
Direction of resolver shaft rotation (viewed from
shaft end) that will cause the postion display to
increase in value.