Rate setup, 24 programming – Electro Cam PS-6144 Series User Manual
Page 52
3-24 Programming
Rate Setup
Menu Path
MAIN SCREEN
to CONFIG MENU
to DISPLAY
RATE SETUP
Purpose
The Rate Setup function allows you to configure the RPM display on the Main Screen.
Three parameters can be programmed:
• Units—The Main Screen can label the resolver speed as Revolutions Per Minute
(RPM), Bags Per Minute (BPM), Cartons Per Minute (CPM), or Inches Per Minute
(IPM).
• Rate—The ratio of actual resolver RPM to displayed RPM. This ratio is a fraction
consisting of a multiplier (MPY) over a divider (DIV).
• Decimal Points—The controller divides the Rate by 1, 10, 100, or 1000 to display 0,
1, 2, or 3 decimal places, respectively.
Screen
Following are a few examples of the relationships between multiplier (MPY), divider
(DIV), decimal points (DP), actual resolver speed, and displayed resolver speed:
If
And
And
Then
And a
Is
MPY
DIV
DP
MPY/DIV
Resolver
Displayed
Is…
Is…
Is…
Is…
Speed Of…
As…
1
2
0
.5
100 RPM
50 RPM
1
2
1
.5
100 RPM
5.0 RPM
1
2
2
.5
100 RPM
.50 RPM
1
2
3
.5
100 RPM
.050 RPM
1
1
0
1.0
100 RPM
100 RPM
1
1
1
1.0
100 RPM
10.0 RPM
1
1
2
1.0
100 RPM
1.00 RPM
1
1
3
1.0
100 RPM
.100 RPM
2
1
0
2.0
100 RPM
200 RPM
2
1
1
2.0
100 RPM
20.0 RPM
2
1
2
2.0
100 RPM
2.00 RPM
2
1
3
2.0
100 RPM
.200 RPM
Programming
Units—Move the cursor to the “Units” field and use SEL to toggle between values.
MPY & DIV—Move the cursor to MPY or DIV and use the numeric keys followed by
ENT to enter a value.
DP—Move the cursor to DP and use SEL to toggle between values.
MPY: 1< DP: 0
DIV: 1 RPM
Units: RPM, BPM, CPM, IPM
Divider: 1 through 63
Number of decimal points displayed: 0, 1, 2, or 3
Multiplier: 0 through 1091