E-Mon Energy Software User Manual
Page 94
Recorder
E-Mon Energy User Manual
8-17
E-MON
Changing the Data Recorder Parameters
To change the Data Recorder Parameters:
1
Click on the Access DBase button.
2
Click on the Recorder Tab, in the Data Recorder Parameters group, select the Profile
Interval
from drop-down.
3
Select the Peak Demand from the drop-down.
4
Select the Rolling Demand from the drop-down. Note: The End of Interval is built in and
it is not necessary to select from the drop-down
5
Click inside list box on each time increments and enter the min. and max. Time
Adjustment
or click on the Sup T down arrows to adjust the time frame for each
increment.
6
Select the Time Zone from the drop-down list.
7
Click on Enable DS Time.
8
Click on the S
END
R
ECORDER
button, to accept/send the data to the recorder.
Reading and Downloading the Hardware Profile
To download the Hardware Profile:
1
From the Access Function Group, click on Read Hardware.
The system will read the meters and display profile status (i.e., Status, Start Date, Days left
from last Download, Sampling Rate, State (On/Off), Last Time downloaded data
(Download Thru), and how many Days left to Download to Avoid Data Lost).
Optional: If only reading one meter, select JustOne and choose from the drop-down list to
the right.
Figure 8.28 - Access Group Profile Status
2
If you want to force a download of all data from the recorder, check All data from the
recorder prior to clicking the Download Button. The download process will begin and be
shown in the Downloaded Thru and status bar in the lower left hand corner. When down-
load is complete, the status bar will indicate – status complete.
Download Process
is shown in the
Status Bar
and
Downloaded
Thru
Column