E-Mon Energy Software - Manual (Page 99)

Meter
E-Mon Energy User Manual 9-4 E-MON
The Access location has the same fields except for the buttons above the meter panel. Note: Before sending
information to the Meter or Recorder, ensure that all information is correct.
Figure 9.2 - Access Location – Access Dbase Meter Tab
Panel Group/Field Description
Send Recorder Click this button to send the recorder configuration to the recorder. You must
be on the Recorder or Location tab to perform this step. If you’re on the
Location tab, recorder configurations for all recorders at this location will be
sent respectively. If you’re on the Recorder tab, configuration for the current
recorder will be sent.
Send Meter Click this button to send the meter configuration to the recorder. You must be
on the Meter, Recorder, or Location tab to perform this step. If you’re on the
Location tab, configurations for all the meters at this location will be sent
respectively. If you’re on the Recorder tab, configuration for all meters in the
current recorder will be sent. If you’re on the Meter tab, configuration of the
current meter will be sent.
Set Password Click this button to send the password setup to the recorder. You must be on
the Recorder or Location tab to perform this step. If you’re on the Location tab,
the password will be sent to all the recorders at this location. If you’re on the
Recorder tab, the password will be sent to the current recorder.
Set Call-in AMR Click this button to send the call-in (call-home) setup to the recorder. You must
be on the Location tab to perform this step. Call-in AMR schedule will only be
sent to the recorder with Device ID “1A.” If you are utilizing the Call-in AMR
(also referred to as Call-home), the Device 1A is responsible to initiate the
calling in. If the location has multiple recorders in the same RS-485 network,
the additional recorders will tack along the 1A once connected.
Set Load Control Click this button to send the load control setup to the recorder/meter. You must
be on the Meter, Recorder, or Location tab to perform this step. If you’re on
the Location tab, settings for all the meters at this location will be sent
respectively. If you’re on the Recorder tab, settings for all meters in the current
recorder will be sent. If you’re on the Meter tab, settings of the current meter
will be sent.