Allied Telesis AT-WA1104G-10 - Manual (Page 23)

Features in 291-08 23
Version 291-10
C613-10488-00 REV G
CR00006303 SNMP 3 On AR725 and AR745 routers, which have no VLAN support, an SNMP Get
request for dot1qMaxVlanId or dot1qMaxSupportedVlans incorrectly
returned a value.
This issue has been resolved.
- Y - - - - - - - - -
CR00006613 Bridge 3 Predefined bridge protocols XEROX PUP and PUP Addr Trans with the
encapsulation of EthII and protocol type 0x0200 and 0x0201 are invalid
and obsolete, since they are less than the minimum ETHII protocol type of
1500 (decimal). Bridging with these protocols could cause the router to
reboot.
This issue has been resolved by replacing the predefined protocol types with
the more modern equivalents 0x0a00 and 0x0a01. Also, if you enter a
protocol type less than the minimum, the router now displays an error
message.
Y Y Y - - - - - - - -
CR00007394 GUI 3 When a user used the GUI to attempt to delete a local interface that was in
use by another protocol, the operation (correctly) failed, but the GUI did not
display an error message to explain the failure.
This issue has been resolved.
Y Y Y Y - Y Y Y - Y Y
CR00007404 MSTP 3 If a network running MSTP was connected to a network running RSTP and
MSTP message debugging was enabled on a switch, the debug output
could loop for a very long time with invalid data.
This issue has been resolved.
- - - Y Y Y Y Y Y Y -
CR00007926 Switching,
IP Gateway
3 The x900 series switches did not send an ICMP Redirect packet when they
received a packet and the route to the packet’s destination was back to the
packet’s sender. The switches routed the packet back to the source but did
not send an ICMP Redirect message.
This issue has been resolved. The x900 series switches now send an ICMP
Redirect message.
- - - - - - - - Y - -
CR Module Level Description AR4
00
AR7
x5
AR7
x0S
Rap
ier i
Rap
ier w
AT
-8800
A
T-8
600
A
T-8
700
XL
x900
-48
A
T-
99
00
A
T-9
800