Level 4 – Allied Telesis AT-WA1104G-10 User Manual
Page 53
Features in 291-05
53
Version 291-10
C613-10488-00 REV G
Level 4
CR
Module
Level
Description
AR40
0
AR7x
5
AR7x
0S
Rapi
er i
AT
-8
800
AT
-8
6
0
0
A
T-87
00XL
x
900
-48
A
T-
990
0
AT
-9
8
0
0
CR00000396
IGMP
4
If a static IGMP port went link down, it was not shown in the “Static Ports” list
in the output of the show ip igmp command. This was only a display issue.
This issue has been resolved.
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
CR00011560
Install
4
It is no longer possible to specify a compact flash file as the boot configuration
file. If the command set config=cf:filename.cfg is entered, the router or switch
does not change the current boot configuration file and instead displays the
following error message:
Cannot specify configuration file in Compact Flash
-
-
Y
-
-
-
-
Y
Y
Y
CR00013976
IGMP
4
The list of parameters output by the “?” help for show ip igmp ? incorrectly
included “IGMP”.
This issue has been resolved.
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
CR00015543
Bridge
4
In output of the command show bridge spanning, the bridge identifier was
correctly displayed as a hexadecimal number, but it was not obvious that the
number was hexadecimal.
This issue has been resolved. The output now has 0x in front of the hexadecimal
number, to make it clear that it is hexadecimal.
Y
Y
Y
-
-
-
-
-
-
-
CR00016126
QoS, Switch
4
When a QoS policy was associated with a port that was set to a speed less than
the maximum speed of the port, a warning message would be displayed on the
console session and in the log when the port state changed to UP. This message
stated that the QoS policy operation may be affected by the speed setting of the
port. Having this message displayed on the console was considered unnecessary
and potentially confusing.
This issue has been resolved.The message is now only displayed in the log.
-
-
-
Y
Y
Y
Y
Y
Y
Y
CR00016451
IP Gateway
4
When a second metric was displayed in the output of the command show ip
route (because of OSPF, for example) this metric was truncated to 2 characters.
This issue has been resolved. The output now displays both metrics in a field up
to 10 characters long.
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y