Allied Telesis AT-WA1104G-10 User Manual
Page 73
Features in 291-04
73
Version 291-10
C613-10488-00 REV G
CR00014755
BOOTP
IP Gateway
3
It was possible to add a BOOTP relay destination using an interface that was not
running IP. It was also possible to delete an IP interface even though BOOTP relay
destinations were defined for the interface. Both of these situations could allow
the router or switch to be mis-configured.
This issue has been resolved by adding checks for these situations to the
command handlers. It is no longer possible to add a BOOTP relay destination
using an interface not in use by IP, and no longer possible to delete an IP interface
if BOOTP relay has destinations defined using that interface.
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
CR00014782
PIMv6
3
The command show pim6 staterefresh sometimes corrupted the terminal
display output with random characters. To recover, it was necessary to reset the
terminal session.
This issue has been resolved.
Y
Y
Y
Y
Y
–
–
Y
Y
Y
CR00014872
GUI
3
The router or switch rebooted if the Opera browser was used to browse to its
GUI.
This issue has been resolved. However, note that the GUI does not fully support
Opera. Some functionality may not be available.
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
CR00015107
GUI
3
HTTP pipelining did not operate correctly on some web browsers when browsing
to the GUI. This made some images very slow to load.
This issue has been resolved.
Y
Y
Y
Y
Y
Y
Y
–
Y
Y
CR00015126
IP Gateway
3
For IP filters of type=routing, the first filter entry could not be set to match on
the following IP address/mask pair:
source=0.0.0.0 smask=255.255.255.255
This IP address/mask pair corresponds to the default route.
This issue has been resolved. You can now match on the default route in the first
entry of a filter.
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
CR
Module
Level
Description
AR4
00
AR7
x5
AR7
x0S
Rap
ier i
AT
-8800
A
T-8
600
A
T-8
700
XL
x900
-48
A
T-
99
00
A
T-9
800