Allied Telesis AT-WA1104G-10 - Manual (Page 46)

Features in 291-05 46
Version 291-10
C613-10488-00 REV G
CR00016940 Core 2 Some versions of the AT-G8T GBIC prevented the switch from detecting and
setting up the AT-A47 expansion board correctly. This issue occurred on start-up
when the GBIC was installed and had a link up.
This issue has been resolved.
- - - - - Y - - - -
CR00016941 IP Gateway 2 When there were multiple routes to a destination and the best route was deleted
from the switch’s hardware routing table, the switch did not use the alternative
route. Also, the switch only used the best route, even if ECMP was supported.
This issue has been resolved. When multiple routes exist and the best route is
deleted from the hardware table, the switch now adds the next best route to the
hardware table correctly. If the switch supports ECMP, all routes are now added
to hardware, not just the best route.
- - - Y Y Y Y Y Y Y
CR00017006 Switch 2 Previously, the link to the AT-G8T GBIC would not come up automatically when
its auto-negotiation slide switch was set to “on”. This was because the switch
configured the GBIC in a fixed speed mode by default.
This issue has been resolved. The link now comes up automatically when the
auto-negotiation slide switch is set to “on”. To bring the link up when auto-
negotiation is set to “off”, use the command:
set swi port=port-list speed=1000mf
- - - - - - - - - Y
CR00017031 IGMP
Snooping
2 If a port on the router or switch joined and left many IP multicast groups, the
router or switch sometimes did not transmit all multicast packets to all receivers.
This issue has been resolved.
Y - Y Y Y Y Y Y Y Y
CR00017036 Switch 2 In some trunk configurations, the STP state of trunks was incorrectly applied to
non-trunk ports. This could result in incorrect traffic flows in the network. This
issue has been resolved. - - - - - - - Y Y -
CR Module Level Description AR4
00
AR7
x5
AR7
x0S
Rap
ier i
AT
-8800
A
T-8
600
A
T-8
700
XL
x900
-48
A
T-
99
00
A
T-9
800