Allied Telesis AT-WA1104G-10 - Manual (Page 28)

Features in 291-08 28
Version 291-10
C613-10488-00 REV G
CR00013494 IP Gateway 3 Once a default local IP address had been set, it could not be deleted. This
was because the default interface does not have an interface number, but
to delete a local interface, the user must specify the interface’s number.
This issue has been resolved, by adding an option called default to the
delete ip local command. To delete the default local interface’s address,
use the command:
delete ip local=default
Note that this resets the interface, including removing its IP address, but
does not remove the interface itself.
Y Y Y Y Y Y Y Y Y Y Y
CR00013543 DHCP 3 If a user attempted to add a policy option to a DHCP policy by using the set
command instead of the add command, then the resulting error message
did not clearly indicate the cause of the error.
For example, entering the command:
set dhcp policy=test arptimeout=234
resulted in the error message:
Error (3070061): ARPTIMEOUT not found.
This issue has been resolved. The error message now reads:
Error (3070279): Option ARPTIMEOUT was not found in policy test or
was not added using the ADD DHCP POLICY command.
Y Y Y Y Y Y Y Y Y Y Y
CR00013635 Ping,
Traceroute
3 In the set trace command, it was possible to specify a minimum TTL value
that was higher than the maximum TTL value.
This issue has been resolved. The minttl and maxttl parameter are now
checked to ensure that the value of minttl is less than or equal to the value
of maxttl.
Y Y Y Y Y Y Y Y Y Y Y
CR00013637 Ping,
Traceroute
3 If the value specified for the minimum time-to-live parameter (minttl) of
the traceroute command exceeded the value set for the maximum time-
to-live parameter (maxttl), the router or switch would attempt to execute
the trace rather than generate an error message.
This issue has been resolved.
Y Y Y Y Y Y Y Y Y Y Y
CR Module Level Description AR4
00
AR7
x5
AR7
x0S
Rap
ier i
Rap
ier w
AT
-8800
A
T-8
600
A
T-8
700
XL
x900
-48
A
T-
99
00
A
T-9
800