Allied Telesis AT-WA1104G-10 - Manual (Page 47)

Features in 291-05 47
Version 291-10
C613-10488-00 REV G
CR00017074 DHCPv6 2 DHCPv6 prefix delegation contained the followed issues:
■ previously, the command create dhcp6 range accepted ranges with an
invalid prefix length.
This issue has been resolved. The router or switch now displays an error unless
the prefix length is in the range 48-64.
■ previously, when the router or switch requested a prefix to delegate to its
appint interfaces, it could only use prefixes of length 48 or 64.
This issue has been resolved. The requesting router or switch can now use any
prefix that has been delegated to it, as long as the prefix length is less than or
equal to 64 bits.
■ The requesting router or switch would allocate an address to the interface
through which it connects to the delegating router or switch.
This issue has been resolved. The router or switch no longer does this.
Y Y Y Y Y - - Y Y Y
CR00017076 IPsec 2 When entering the command set ipsec policy, the value of the
respondsetbadspi was incorrectly reset to its default of false, unless it was also
included in the set command.
This issue has been resolved.
Y Y Y Y Y - - - - -
CR00017146 IP Gateway 2 When the router or switch’s Local address was pinged, the router or switch
responded from the interface address of the interface through which it received
the ping, instead of the Local address to which the ping was sent. This issue has
been resolved. Y Y Y Y Y Y Y Y Y Y
CR00017151 Telnet 2 When Reverse Telnet was enabled the command shell was (correctly) disabled on
all ASYN ports apart from ASYN0. However when Reverse Telnet was disabled
again, the command shell was not re-enabled on the other ASYN ports.
This issue has been resolved.
Y Y Y Y - - - - - -
CR00017239 VLAN, IGMP
Snooping
2 When a user configured IGMP static router ports, the configuration file produced
by the command create config could be invalid. When the router or switch ran
the resulting configuration file on start-up, it produced an error instead of
configuring the router ports.
This issue has been resolved.
Y - Y Y Y Y Y Y Y Y
CR Module Level Description AR4
00
AR7
x5
AR7
x0S
Rap
ier i
AT
-8800
A
T-8
600
A
T-8
700
XL
x900
-48
A
T-
99
00
A
T-9
800