IDEC DATAVS2 Series - Manual (Page 11)

Instruction Manual SVS2 Series
6
4.4. Communicating with the sensor
Communication with the sensor occurs via the Ethernet network.
Two types of connection are possible:
direct connection: personal computer is connected directly to device using a "
cross cable ".
Through LAN: use common network (non-cross) cables normally used to connect devices to routing
hubs.
This network architecture is termed "star" configuration because all network cables are connected
to a central HUB.
Hub
Desktop PC
Notebook
Printer
Plotter
SVS2
It is essential that the
IP addresses of personal computer and device be compatible.
The Graphic User Interface offers a discovery feature that automatically searches for and locates any
sensors in the network and displays their IP address and Subnet Mask information. After selecting the
desired sensor, you may proceed to set inspection settings (see page 22).
4.4.1. Check PC Network Settings
It is essential that the IP addresses of your personal computer are compatible to those of the sensor to
successfully set up a communication.
Note: You need to have administrator rights established for the present user logged in to follow the next
instructions. If this is not the case, please contact your local IT manager for assistance in creating this.