IDEC DATAVS2 Series - Manual (Page 24)

SVS2 Series Instruction Manual
19
6.2. STEP 1
During this first step, you must decide how you want to go about the inspeection configuration
procedure. You may choose to connect to sensor first (On-Line mode) or choose local mode (Off-
Line mode). Each mode offers different options:
Off-Line Mode
• New Inspection : Creates a new inspection;
• Open Inspection from PC : Loads parameters of an
existing inspection saved on PC.
On-Line Mode
The system searches for connected sensor in the
network and displays their network addresses (IP and
Subnet Mask address). When connection is made, you
may select one of three parameters:
• New Inspection : Creates a new inspection;
• Open Inspection from PC : Loads parameters of an
existing inspection saved on PC;
• Open Inspection from SVS : Displays inspections from
sensor to allow their configuration parameters to be
imported to the graphic user interface.