IDEC DATAVS2 Series - Manual (Page 17)

Instruction Manual SVS2 Series
12
5.1.3. Setup bar
The Setup bar lets you complete the system configuration procedure in 3 steps.
The procedure is described in detail further below; to make it easier, it has been divided into three
steps:
• Choose inspection mode (step 1);
• Set trigger signal, controls and locators (if needed) (step 2);
• Set outputs and Test and Run modes (step 3).
As you proceed through the setup process, your progress is visually highlighted by the step you have
just reached activating and the number label turning red.
5.1.4. Control Panel
The control panel offers several different functions depending on the current setup step and the
operation you are carrying out. For instance, it lets load and/or set up the reference image, or view and
change the parameters of the controls in use.
Initially, the control panel will be blank. The system is waiting for the
user to choose how to start the setup process.
If you choose to start the setup process in the Off-Line mode, you will
need to load a stored image and confirm that this is what you want to
use as your reference image.
The control panel will look like this. A stored image may also be loaded
from here, besides from the Setup bar.